eCigarette Forum > Modding
DNA 12 Evolv w/ an MCU
jmarkus:
hey break,
do you know if i can use this charger:
http://www.sparkfun.com/products/10401
with this battery, 3.7V 1200mAh 20C Lipo Li-polymer:
http://www.ebay.com/itm/320892649444?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
wondering if i can use the charger without any modding with the single cell above using the dna charging terminals?
Breaktru:
--- Quote from: jmarkus on June 18, 2012, 07:28:15 PM ---hey break,
do you know if i can use this charger:
http://www.sparkfun.com/products/10401
with this battery, 3.7V 1200mAh 20C Lipo Li-polymer:
http://www.ebay.com/itm/320892649444?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
wondering if i can use the charger without any modding with the single cell above using the dna charging terminals?
--- End quote ---
Yes. that is the same charger I'm using.
jmarkus:
thanks so much man. thought so and had ordered 3 of each (batteries and chargers) but wanted to make sure.
jmarkus:
should i go battery out to battery in on dna and charger board out to charger in on dna?
would there be a different or better setup like going battery out to charger board and then charger board to battery or charger in on dna? will it work as a passthrough in any scenario?
Breaktru:
--- Quote from: jmarkus on June 18, 2012, 08:23:04 PM ---should i go battery out to battery in on dna and charger board out to charger in on dna?
would there be a different or better setup like going battery out to charger board and then charger board to battery or charger in on dna? will it work as a passthrough in any scenario?
--- End quote ---
For convenience I went battery to DNA battery terminals and charger to DNA charger terminals.
According to Brandon, the the Charger terminals on the DNA is the same as the battery terminals.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version