Breaktru Forum
eCigarette Forum => Modding => Topic started by: SolarRay on April 19, 2012, 11:23:34 PM
-
I noticed the OKR series from Murata is available in an "E" model....force enable.
Could these be switched on via a logic level touch switch? Rather than a power MOSFET touch switch... Of course the design would have to included a Master switch.
-
Yes, but you can also add a 10k pull down resistor to the standard version and use a logic level touch switch.
-
Yes, but you can also add a 10k pull down resistor to the standard version and use a logic level touch switch.
Thanks Cape for the advise. Do you have a drawing?
-
hi i am sure that it is a 100k for the okr-t3 and a 10k for the okr-t 6 and 10 i thought that it was the 10k for all three but after reading all through the okr trend on the ecf i have found out that the okr-t-3 was 100k :beer-toast: jimmy
-
10k will work for the T/3 also
-
Thank you i was looking for this info aswell i will be testing this weekend i hope :thankyou:jimmy
-
Thanks CapeCad, I have also been looking at depletion mode MOSFETS, It can act as a "normal closed" transistor based switch. But a 10k resistor sounds easier. Anyone know where to get the E model? it seems impossible to get anyway.... A solution with the standard model seems more practical.
-
I have been looking for the OKR-T/6-W12E-C and can't find any. This is the "Forced Enabled" model.