i've been searching the internet to learn how to build these tin mods for my first attempt. is there anyone that can point me to a step by step process or help me out. Parts also?
Here is a tutorial video that will teach the basics. The same principles can be applied to a tin or other enclosure. This aired originally on Vapourtrails.tv.
TutorialMy
List of parts/Supplies;
Enclosure of your choice
510 connector-pre wired or not
Switch normally open momentary 3amp or higher if you want to go below 1ohm(10+amp)
wire-20gauge,for a everyday vape. 18 or 16 gauge if going sub ohm
Battery holder. I recommend Keystone. I some time build my own.
Battery. Get a really good one. Don't pinch pennies here. Lot's of really good one's list on these forums
Optional items;
On/Off switch rated above 3amps.....I put this here because I remove my batteries when I am not using my mod
Led and a resister
Voltage meter(DMM)....I just check mine with a multi meter