Wired w/ no caps 500 ohm 12 turn pot
4 amp power supply pushing it to 7amps infrequently no problems
Very small enclosure its my daily used uber comfortable in hand
slight angle bend to 510 mount for my drippers to not drip on me when holding it and computing, before angle I had spots on my pants everyday lol..
Its an ug mug enclosure tape wrapped cause box is 100 years old, its the electronics holder out of an old lamp; seriously probably 50 years old. the plastic crumbles instead of shave -- made way before good plastic technology..
Its ug mug brother mr 4050 passthru 5-12v prettied up with bob marley lol
powered by 5v passthru 2.5a at this photo then on to a 3v 300watt rail old dell computer ps
Its where I started modding pre break4050 and breaktru site learns, was using egos and a very badly made 4050. It now has a bad ego head on the homemade adapter from an e9 cart -510, I can still use my greensmoke carts on it.
I didn't even have an iron I used a heated screwdriver on stove to solder
worked great
90% of my tools were stolen $$$$ doing a rehab in da hood a few days before, my whole rig except my small tool bag and only cause I had another small job that night so I didn't leave it, they tore the iron gates off the door and alarm off wall!
ti had shipped so fast was anxious -- I found my old iron in garage later..
Marley switches with old car point contacts under a bent brass button paper clip
great switch w/ silver contacts