Has anyone here tried the Lemo atomizer by Eleaf? Got one in last night, and am quite happy so far. It’s a derivation of a Kayfun, but with several improvements, to my mind.
First, airflow can be much better than a KFL+, but it’s adjustable so you can tighten it if you wish.
It comes standard with a glass tank, and the top of the chimney threads into the top cap so no worry of it coming apart like a glass conversion on a Kayfun. Replacement glass seems to be available at Vaporcompany ($5.00)
My experience is that Kayfun types only leak if the tank isn’t sealed, but if this one were to, the design of the bottom assembly would catch a lot before it came out the (four) air holes. You can put that as a plus or a minus, I guess.
It is a little taller than a KFL, but it claims to hold a full 5ml. With both tanked up and ready to go, the Lemo is about 15 grams lighter than my KFL+.
It came pre-coiled and wicked with 26 gauge on a 3 mm mandrel, and I must say that the coil was the best looking factory coil I have seen. I disassembled, tossed the wick, gave it an ultrasonic bath and re-wicked the factory coil. I only have limited experience, but this is the closest I have seen a tank come to a dripper. So yeah, happy.
Side note: that factory coil was not close wound, but it did burn evenly. I have some juice that will clog a Kayfun in one tank, using 28 gauge tight wrapped on a 2mm mandrel. Gonna see if a spaced out coil can survive longer. Will update.
Wayne
Well, the spaced out coil did last longer than a smaller close wound coil. But that juice is rough on coils. Here is the results of about 7ml.