0 Members and 2 Guests are viewing this topic.
ETA - OK, I think I read that wrong...in this case you would want to run R2 to Rh (V+ in this instance), correct?
Haven't yet tried it but yes I believe the value of R2 should be between Rh to V+.Remember, the values are in KiloOhms. So that would be 100 ohms for R1 and 100 ohms for R2.
thank you for the feed back you have saved me ALOT of brain ache. i think I'm going to stick with the 200 ohm pot with the okr and keep with the 100k DP on the 4050c until someone comes out with a DP more suitable with push button control.On a slightly different note do you think these mosfets would be OK for a tact switch IRLU9343PbFVds 55vVgs 20VId 20AVgs(th) -1VOnce again thank you for your help its been a real help since vaping not only am i saving money feeling healthier i have also found my self with a new hobby
Okay, this might be a dumb question, but do you have to insulate the outside of the switch from the tube? If you used two different contacts instead of one inside the other, would you insulate both? I know they have to be insulated from each other, but from the body? Excellent mod, by the way, but it's a long way off for me.
Breaktru,I'm getting ready to build this board for my 1st. mod. You diagram shows batteries in series. I'm planning 2x 19650 Panasonic NCR18650PF 3.6V 2900mAh. Question; can I wire them in parallel? would make usb charging easier.Jasen
I think this P-Channel Power Mosfet IPD90P03P4-04 would be better suited as it has a Low Drain-source on-state resistance RDS(on) rating of only 4.5 mOhmsGate threshold voltage VGS(th) is: Min -2.0, Typ -3.0 Max -4.0