Breaktru Forum

eCigarette Forum => Modding => Topic started by: whoi on April 03, 2014, 04:49:12 AM

Title: My Naos Raptor Build
Post by: whoi on April 03, 2014, 04:49:12 AM

Two white shafts on top are the potentiometer and a switch for Vin/Vout to the voltmeter. I am going to frame the voltmeter sometime this weekend.

(http://i.imgur.com/9dpWx5q.jpg)

(http://i.imgur.com/n7u7Cii.jpg)

(http://i.imgur.com/cKP0ECt.jpg)

Thanks to mamu and CraigHB for all the great input on the original thread. And thanks Breaktru for hosting a great site for sharing these ideas.

Title: Re: My Naos Raptor Build
Post by: mamu on April 03, 2014, 07:06:56 AM

Well done, whoi!  :thumbsup:

Title: Re: My Naos Raptor Build
Post by: thejewk on April 04, 2014, 09:52:02 AM

Nice work there mate, looks tidy.

Tried any crazy watts yet?  freaked_out:

Title: Re: My Naos Raptor Build
Post by: Breaktru on April 04, 2014, 09:58:38 AM

Looking good @whoi  :rockin smiley:

Title: Re: My Naos Raptor Build
Post by: whoi on April 05, 2014, 04:24:03 PM

Thanks for the kudos guys!

Quote

Tried any crazy watts yet?

I tried a .3ohm coil at 6v with a cotton wick. Burnt the wick lol. Also for kicks I put in my igo-w3 with quad coils with no wick; .4ohms @ 6v was a light bulb.

Also went out last night with my .3ohm setup @ 4.2v. I went from ~7.8v to ~7.2 over about 5-6 hours. Pretty stoked with that.

Title: Re: My Naos Raptor Build
Post by: thejewk on April 05, 2014, 04:55:22 PM

That's not bad efficiency at all on a build like that.  Good work!

Title: Re: My Naos Raptor Build
Post by: JonGio on April 05, 2014, 10:57:22 PM

Very nice work sir.  I have three of those chips waiting to be played with.  In fact some inspiration may have just struck me.  I may go breadboard something up right now.   ;cheers;

Title: Re: My Naos Raptor Build
Post by: jgw1986 on May 21, 2014, 03:16:37 PM

Looks great! Where did you get that 510 connection?