Breaktru Forum
eCigarette Forum => Modding => Topic started by: jester on May 19, 2012, 07:06:21 AM
-
i have just made this with okr t10 battery volts and vaping volts display i have put master on off as i used pin 1.i killed my first 1 i got the full volts to pin 4 from the display
-
Very nicely done jimmy. Lookin good my friend. conrats.
I like the buttons. cool
-
cost alot but will last i hope :thankyou:
-
i would like to thank all the moders that share all the info :beer-toast:
-
just made this with a touch switch and okr-t6 i used irlu3114 mosfet its small but not too small i used 10 meg resistor work good i would of liked to try couple of diffrent resitors but could only get 10 m i used 2 copper nails for touch points i need to get a good dig pot were isgood to get one and which one is good cheers jester
-
Very nice and w/ a touch and Digital Pot :beer-toast:
-
Damn, you guys are such great craftsmen. That is really nice looking.
-
thank you this one as no dig pot that is my next step i have one in a test mod i just can not stop cheers jester
-
Hey jester on the top picks did you run the voltage check on the switch out? I ask because it looks like you are holding the switch in to get voltage reading. Also does your display just show you voltage right off the bat or does it run through cell 1 first then cell 2?
-
you can put it either side of the switch it gives total battery voltage i would like to do it for each cell mabe next thing to learn .cheers jimmy