Breaktru Forum

eCigarette Forum => Atty/Carto/Tank/Rebuildable => Topic started by: zeus17 on October 16, 2013, 12:23:12 PM

Title: i am at it again,this time a different approach...aga t2,horizontal build,drips
Post by: zeus17 on October 16, 2013, 12:23:12 PM

(http://m.imgur.com/mwFKQvC)

so this one is a different approach..

i mean most genny would build vertically,this one i kinda utilized the negative post on the the other end,rather than the fill screw as my negative post on my previous builds.

the wick is cotton,so its nice and easy,
now what is not on the pix is the reduced chamber,since the aga has a large chamber it reduces the flavor sorta..
so what i did was got a cork from an old wine bottle,cut to fill the other half of the chamber,then torched just to clean the wine and dirt that might have been there.
results were increased flavor and vapor production...
for got to mention that airhole was 3mm

Title: Re: i am at it again,this time a different approach...aga t2,horizontal build,drips
Post by: Breaktru on October 16, 2013, 01:07:24 PM

The photo is not showing up in your post.
When using an on-line photo hosting site, link to the picture and not the web page.
The ending link extension should be .jpg .gif .png ...... etc.....


(http://i.imgur.com/mwFKQvC.jpg)

Good one Zeus  :rockin smiley:

Title: Re: i am at it again,this time a different approach...aga t2,horizontal build,drips
Post by: zeus17 on October 16, 2013, 01:12:28 PM

thanks sir, maybe because the photo was uploaded via my mobile phone,still thanks for catching that.

hopefully this helps a couple of vapers that has stored away their gennies because of frustration.

Title: Re: i am at it again,this time a different approach...aga t2,horizontal build,drips
Post by: steamEngine on October 16, 2013, 03:22:58 PM

Nice going  :thumbsup:
Are both ends of the wick inside the tank?

Title: Re: i am at it again,this time a different approach...aga t2,horizontal build,drips
Post by: zeus17 on October 16, 2013, 04:55:32 PM

nope...none of them are inside the tank,,,
apologies for the poor photo...

i just did not cut the end of the cotton,both are just laying down on the bottom of the deck so if any juice are on the other side the end part of the cotton seeps them

it basically works as a dripper,then if i needed juice i just tilt the thing...

Title: Re: i am at it again,this time a different approach...aga t2,horizontal build,drips
Post by: octoman on October 16, 2013, 05:09:32 PM

Intuitive!  :beer-toast:
A dripper without the need to drip  :laughing:

Title: Re: i am at it again,this time a different approach...aga t2,horizontal build,drips
Post by: zeus17 on October 16, 2013, 05:35:49 PM

Thanks,it was born mainly due to the frustration on mesh and having to build vertically...

i know that someone in you tube has this thou rip something...has a tutorial similar to this build if you need assistance in building something like this,,,