Breaktru Forum
eCigarette Forum => Modding => Topic started by: Madyicstik on May 15, 2014, 12:59:52 PM
-
Ive done 3 ti chip mods and would like to ask you guys if anybody would know where the input power goes on this specific power supply (neutral and hot)
I got this off a rack system and would like to re purpose it for the " vapestation" tha i made. 26 a would power 3 ti mods that ive done and will act as a pass through! Can anyone help me i dentify out of the prongs on the picture attached which one is for hot and neutral?(http://i835.photobucket.com/albums/zz279/madyicstik/imagejpg1.jpg)
(http://i835.photobucket.com/albums/zz279/madyicstik/imagejpg2.jpg)
(http://i835.photobucket.com/albums/zz279/madyicstik/imagejpg3.jpg)
Thanks in advance!
-
Give these guys a call, I betcha they can give ya the correct setup for the power distribution board pinout..
http://www.txcesssurplus.com/servlet/the-4237/NEW-Dell-7T602-PowerEdge/Detail