Breaktru Forum

eCigarette Forum => Atty/Carto/Tank/Rebuildable => Topic started by: Breaktru on December 05, 2013, 10:44:01 AM

Title: RBA Screw Thread Size
Post by: Breaktru on December 05, 2013, 10:44:01 AM
I was looking for the thread size for the tiny screws in two of my rebuildable attys and couldn't find any specs by Googling. I decided to buy a couple of sizes to see if they would fit.
I found that an m2.0 x 4 pan head machine screw was perfect and an m2.0 flat washer which I used for my Did clone and Vivi Nova converted to a genisis.
Look for Hobby Hardware
Title: Re: RBA Screw Thread Size
Post by: vaporhead on December 05, 2013, 04:22:08 PM
good to know break.
I was looking for washers to sandwich my coil wire ends.