Author Topic: My Naos Raptor Build (Read 6893 times)

whoi · « **on:** April 03, 2014, 04:49:12 AM »

Two white shafts on top are the potentiometer and a switch for Vin/Vout to the voltmeter. I am going to frame the voltmeter sometime this weekend.

Thanks to mamu and CraigHB for all the great input on the original thread. And thanks Breaktru for hosting a great site for sharing these ideas.

mamu · « **Reply #1 on:** April 03, 2014, 07:06:56 AM »

Well done, whoi!

thejewk · « **Reply #2 on:** April 04, 2014, 09:52:02 AM »

Nice work there mate, looks tidy.

Tried any crazy watts yet?

Breaktru · « **Reply #3 on:** April 04, 2014, 09:58:38 AM »

Looking good @whoi

whoi · « **Reply #4 on:** April 05, 2014, 04:24:03 PM »

Thanks for the kudos guys!

Quote

Tried any crazy watts yet?

I tried a .3ohm coil at 6v with a cotton wick. Burnt the wick lol. Also for kicks I put in my igo-w3 with quad coils with no wick; .4ohms @ 6v was a light bulb.

Also went out last night with my .3ohm setup @ 4.2v. I went from ~7.8v to ~7.2 over about 5-6 hours. Pretty stoked with that.

thejewk · « **Reply #5 on:** April 05, 2014, 04:55:22 PM »

That's not bad efficiency at all on a build like that. Good work!

JonGio · « **Reply #6 on:** April 05, 2014, 10:57:22 PM »

Very nice work sir. I have three of those chips waiting to be played with. In fact some inspiration may have just struck me. I may go breadboard something up right now.