0 Members and 9 Guests are viewing this topic.
When sucking on it don't suffice, you can always inject it into the blood stream
Okay...I'm dying to know why you have a syringe in your tank, Al?
How about using a leather hole punch for the hole in the rubber stopper just lube it with vg/pg and it cuts like a hot knife through butter and nice clean cut
Incidently, I left the writing on the hypo, too lazy to scrub it off. Next one will be cleaned off. Any idea how to remove the lettering from the outside of the syringe?
http://www.ebay.com/itm/280650240353?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 link to e-bay for leather hole punch
Every one needs toys I mean tools
I like the fact you put so much effort to help every one here I meant no disrespect
It's been over a month using the same tanks and cartos and occasionally I would experience a siphoning effect where after filling a fresh tank it would leak thru the carto center hole.I found that blowing some juice out thru the drip tip and then holding my finger on the center bottom hole while still blowing would alleviate the siphoning.Other than those rare occurrences, the tanks and washers are perfectly sound with NO leaking and plenty of draw.Update:Like I said, I've been using the same cartos for a month. The siphoning was caused because the draw was a bit harder so I had to suck a little harder which caused the siphoning. It's like siphoning a gas can with a hose.After several refills, periodic cleaning is required for your carto. Blow out the old juice and run cool water thru the top and continue blowing repetitively. Blow out the water and let sit for a day or two and your carto will be as good as new.
I got all excited about this when I saw it thinking I'd be able to use some off the shelf items from a hardware store. Then I realized you're using 3/4 ID. I've got 16ft of 3/4 OD poly carb =\Been hunting for vinyl grommets everywhere and hte only places I can find them are online.
how stable is just the washer if you don't do the metal washer on top? worried it'll twist or something and leak :p
Congrats bam, looks pretty good to me.What did you use for for the two end caps?
What do you use to sharpen the blade of the copper tube cutter you using? I am using the same stuff but it is creating a ridge that shrink the size of my tube ID.
Wait...was that metal washers on the outside of the rubber ones?