0 Members and 1 Guest are viewing this topic.
hey Breaktru, got my chip. now, just wanna ask, to test it out, I wire the batteries to the voltage in pins and get the result out of the voltage out, right? my question is in this setup, (without caps and all) what voltage should I get? just wanna make sure I didn't get a dud...
Sorry for the late reply Ginjo. Lost power for 2 days due to Hurricane Sandy.You need caps if your testing with a load.If you are not using a Pot and you leave the adjust pin OPEN, your output will be 0.6v
Amazing mod, as always! What dimensions did you wind up with? As far as 510 connectors, they're out at the moment, but bogger sells them cheap http://www.boggerboxmods.com/index.php?route=product/product&path=63&product_id=93
hi,I still have this old mod of mine using this but just the internals..instead of putting them on a copper mod I practically squeezed them on a Marlboro fullpack altoid can,.,still works and I use it as my daily vape...now I just would like to re do it,problem is last year I had the time to look for tantalum caps and salvage them from old TV's and the likes now I don't...can you suggest a substitute for tamtalum caps?
First off, thanks dave for inviting me over. I have been asking him alot of questions and stuff, sorry about that dave. Anyway, i have been reading from one thread to another but i cant find the circuit or diagram with led in it. Can anyone lease help me.
my chips on the way but i have some questionson the trim pot 200ohms and what WATT rating am i looking for on the potalso will these resistors and quantity work for the modx1- MCM-373-220 OHM 5% 1/8 WATT CARBON FILM x2-PANASONIC-EEU-FM1A101-CAPACITOR ALUM ELEC, 100UF, 10V, 20%, RADIAL
The trim circuit is low amperage. Anything 0.05 watts or higher will do for the resistor and pot. Ideally a 1% tolerance is needed.The resistor will be fine at 5% tolerance but 1% is better for a defined output range. The caps are low impedance so they are good to use. I've used those caps before.
The caps are low impedance so they are good to use.
After being skint for a while I'm finally able to start this project lol, just one question the fuses are rated at 5 amps is that hold or trip current.
Will the fuses provide reverse battery protection.