0 Members and 6 Guests are viewing this topic.
What's inside:
100m ohms at Digikey. I've tried every value under 100m and I couldn't get it to turn fully on unless it was a 100m.You can use a low current tactile N/C sw from the inhibit to ground. But the chip will continue to draw low ma's while idle.
I do notice that, with a 10M resistor, sometimes it won't work unless your finger is slightly moist .. that explains a lot .. What's the 1K used for? I have used my touchie circuit with and without it, seems to work the same either way???
18350's, one in each tube.12ga would be nice. I have 12ga 3" magnum slugs but they are not all metal casings.Have never seen metal casings.
Stupendous Dave. That's the best homemade mod I've seen to date!I simply love it. breaktru ROCKS
Very Sexy looking.Maybe a bit heavy for my delicate hands.Perhaps a couple of 14250's ? I'll PayPal you?
One more question .. you have a digi pot in your diagram, how do you control it? A pair of buttons or
This is really beautifully done. If I may ask, what is the part number for the p-channel FET you are using?
The concept of putting different batteries in without have to change tubes or partsis a fantastic way to do it. Just slide the tube in or out, wow. Great work breaktru.
Can I use 100uf 50v caps? Are the compatible?
Carrying the "Side x Side"
I've tried and failed to make something like this mod.This would be my ultimate mod.Can I buy one from you breaktru?