Another great copper mod. It should be entered in an Art Show. Great work Lear.
What battery are you using? How does the LED turn on? is it switched?
Thanks for the kind words... Just for the record, I did not create the images on the mod. My friend found the images he wanted and I edited them to the correct size and then electro etched them into the mod. I can't draw that good lol!
I am able to use any 18650 battery, trustfire, panisonic and aw's, flat top or button top. Those are all the battery types I have. The only way I could make the LED work was to connect it to the power going to the atty. So when I touch the sensor the light turns on and the atty gets power. I tested it under load using a fully charged aw imr battery and it dropped from 4.10 to 4.08 volts using a 1.7 ohm clearomizer. It may not be the most efficient way to wire it up but it vapes good and the battery lasts all day with moderate vaping. The touch switch is flawless. I used the schematics you posted here on this site for the Ti chip and mosfet. Thanks again Breaktru!