Looking for help with the Milo-DNA20D

[Breaktru]

Glad you found the problem. Now you're a troubleshooter too 

[T8ternutz]

Looking good, Romelee - you're almost there!

I used to seal the underside of the connector with epoxy, but don't anymore. 

As long as the insulator is intact, there won't be any leaks from the connector.  I have switches and screws on the top cap of Lexi and was concerned if juice could get inside the case so did a leak test a while back - let it set for several hours and no leaks at all.

What enclosure is this??

[warlordxxx]

If I remember that's a powerbank enclosure that mamu got and stripped out the innards of - Similar to this empty enclosure http://www.fasttech.com/product/1462503-hp-0127-diy-empty-mobile-power-bank-enclosure

[rhay80]

Should have read this thread sooner, just ordered 6 tactile switches from stealth vape doh!

But after reading through and using the links posted have purchased a few items.

Thanks for the links and advice in here, I now know how to wire up the tactile switches although they are the 300nm I'm sure they will be OK, will look for 200 next time