Author Topic: issue with 20 amp rator build (Read 6821 times)

mrbump82 · « **on:** December 10, 2014, 01:01:43 PM »

Builds been working fine for a while but here lately it's been having an issue with delayed firing any one know what could be causing this. It was built using mamus diagram but I did not use the p fet

mamu · « **Reply #1 on:** December 10, 2014, 05:29:42 PM »

Not sure what would cause this other than the fire switch not making contact at first.

mamu · « **Reply #2 on:** December 10, 2014, 05:30:55 PM »

If you're using a coil with thick gauge Kanthal, that would give a bit of a lag.

CraigHB · « **Reply #3 on:** December 10, 2014, 05:47:14 PM »

Yes it can take some time for a heavy gauge coil to spool up. I've done one with 24ga and it probably took at least a second or two to heat up enough to make vapor.

Breaktru · « **Reply #4 on:** December 19, 2014, 06:26:29 AM »

Yup, same here w/ using 24ga kanthal.

mrbump82 · « **Reply #5 on:** December 19, 2014, 08:15:17 PM »

I think it turned out to be the button he took it apart and rewired it with a vandal switch instead of a tact switch

Author Topic: issue with 20 amp rator build (Read 6821 times)

mrbump82

issue with 20 amp rator build

mamu

Re: issue with 20 amp rator build

mamu

Re: issue with 20 amp rator build

CraigHB

Re: issue with 20 amp rator build

Breaktru

Re: issue with 20 amp rator build

mrbump82

Re: issue with 20 amp rator build